Boat Seats For Sale by Veada

Clearance Sale
Why Shop Veada?
About Veada
Customer Testimonials
Customer Photo Gallery
Installation Instructions
Cleaning Tips
FAQ
Contact Us
The Ten Commandments
Sign-up for our Newsletter
For news on Veada, boat seat product updates, and information about special promotions, please enter your e-mail address below.





    Free ShippingMade in USA
Shop Boat Seats By Phone      Track Your Boat Seat Order

Installing Boat Seats

How do I remove my old pontoon boat seats?

Most boat seats are mounted with lag screws or bolts. Simply remove these screws or bolts and you're on your way to a clean deck.

Back To FAQ

How do I install my new pontoon boat seats?

Installing new pontoon seats is about as simple as removing the old boat seats. Use stainless steel for all installation hardware.

  1. Arrange the new pontoon boat seats into place.
  2. If you desire a snug fit between the furniture, use two stainless steel bolts, washers and nylock nuts to attach each bench to another bench or a bench to an arm. Drill two 5/16" holes about 5" off the deck and 5" apart. Insert 1/4" x 1" bolts, two washers and one 1/4" nut per hole. Tighten until snug.
  3. With the seats in place, use bolts or lag screws for mounting.
  4. (Recommended) For bolt installation, drill one 5/16" hole per corner or four per bench. (Tip: After drilling each hole, drop the bolts in place to make sure your holes line up) Use one 1/4" x 2 1/2" bolt, two washers and one 1/4" nylock nut per hole. Tighten until snug.
  5. For lag screw installation, install one 1 1/2" lag screw with washer per corner or four per bench.

Back To FAQ

How do I mount my helm seat or fishing boat seats?

Most of Veada helm seats will mount to a pedestal top with a 5x5" or 5x12" bolt pattern. Fishing seats will only utilize the 5x5" bolt pattern. The helm seats and fishing seats can be mounted using 1/4" x 20 bolts. Please view the product pages for additional mounting notes on select seats.

Back To FAQ

How do I install my helm console?

Take note on the removal of your existing helm console. Carefully label each wiring harness before removal for easier installation later. Use the same meter layout or improve when installing on the new helm console. All Veada helm consoles will have access doors for easy access for the under-console wiring.

Back To FAQ

How do I install my back to back laydown boat seats?

Install your back to back lounge boat seats in this order:

  1. Install the base box first. This can be installed using similar hardware as your previous bases or use stainless steel molly bolts. Use one bolt / screw per corner or four per base box.
  2. Mount the provided support legs to the seat cushion using the provided 1/4" x 20 x 1 1/2" stainless steel bolts and washers. Each support leg requires two bolts per leg.
  3. On your installed base box, extend the pre-installed scissor hinges outward to the laydown position. Prepare your seat cushion by extending it to the laydown position. Place it on top of the base box. Line up the four holes in the seat cushion bottom (t-nuts pre-inserted) with the holes in the scissor hinges. Mount the seat cushion to the scissor hinges using the provided 1/4" x 20 x 3/4" stainless steel bolts. Each scissor hinge requires two bolts per hinge.

Back To FAQ